While the first option is cheap and easy, it also has its share of problems. To do this task is like running a water line to your home but on a smaller scale. If you are running an actual water line, you will need to bury it plus, you may need to get a permit and have inspections done.

No permits are needed for this set up and it may only cost you the price of the new hose. The first way is to simply run a garden hose from a spigot to the RV. There are two ways to get this project done. Get someone to help you that is experienced in this type of work if you are not sure your skills are up to the task. If there are no leaks, you are done except for clean-up. If there are any, seal them up with the right compounds. Step #5: Run the water faucets in your RV after opening the gray water tank valve. After that, slip the open end of the connector over the sewer opening or valve. Again, make sure the pipe is in the right position, and then slip the 90-degree connector over the open end. Step #4: Now it is time to connect to the other end.

Make sure the connector and pipe are set in the right positions before tightening any clamps or screws. Then slide the PVC pipe into the other end. Slide the connector into place and secure it. it should be designed with a 45-degree angle to fit the RV valve. Step #3: Now take your flexible connector. You can always take some pipe length off but you can’t put it back on.ĭo not forget to smooth out the cut portions and get rid of all the burrs. Keep in mind it is better to cut it longer than shorter. Step #2: Measure the distance from the RV valve to the opening of the permanent sewer’s inlet valve. Step #1: Close all valves on your RV and then twist the termination cap off the drain. Or you can follow the steps we found at this link: There are only six steps involved in that article. It has the steps you will need to do the job properly. You can get to it at this permanent RV setup link. You can read our article that we wrote some time ago. After that, it is a simple matter of hooking everything up correctly. You may have to buy some new hoses that are thicker and tougher when you want to stay in one spot for a very long time.ĩ5% of the job is preparation. Keep in mind that the sewer lines for RVs, etc., are not made for long-term use. Of course, the specific models and shapes of most of the parts will depend on how your black water exit valve is designed and the location of the septic tank or dump spot. You just need the right tools, couplings, and hoses to do the job right. It is also a good idea when you are planning a long-term stay at an RV park or campground. If you are building your own pad and giving your RV or travel trailer a permanent home, this is a good idea.

Rv black water hose connector